For
walls, 2 optional nozzles are available to make the joints from 5 to 25
mm in width.
The
preparation of the pointing mortar for walls must be creamy. The granulation
must be from 0,4 to 0,6 mm maximum in relation with the chosen nozzle and
wished result.
In
the case of work at breast height, the tank can be fully filled. In the case
of a higher work, the tank must only be filled half full in order to avoid
an overflow when the machine is sloped.
Place
the nozzle in the facing joint. Turn the regulator on. Then, the jointing
can be carried out according to the desired type of installation.
When
the jointing is finished, let act-!
You can note not only the speed of realization, the
quality of the joints but also the saving of material used
(estimated at 3%).
According
to the required finish, you only have to smooth with a wet sponge for full
joints, to scrape with a trowel for hollow joints or to scratch with a metal
brush for a rustic completion in order to emphasize the gravelling.
